Showing all 4 results
Home
2K PREMIUM
PRODUCT DESCRIPTION
Health and safety Data
Use in a well ventilated flameproof area.
Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying.
Storage:
Products contain highly flammable solvents.
Store in a flame proof area, away from any source of flame or excessive heat.
The information herein is accurate and factual to the best of our knowledge and is given in
good faith, However, no warranty is implied or expressed in respect of any recommendation
or suggestions contained herein. The onus is on the end user to ensure the sustainability of
this product to meet their requirements.
Health & Saftey procedures when using this product are the end users responsibility.
Twin Pack Auto Coating is a two-pack system ideally suited for use
in the automotive industry.
Chemical Basis: Acrylic Resin System cured with a hardener component
based on isocyanite.
General Qualities: High quality finish with exceptional gloss and durability.
Physical properties:
Density: depending on colour however white is 1.15 Typical (base)
Flash Point: below 21 degree C.
Solid content 40% by voloume / 55% by weight
Viscosity: +/- 75 ku’s @ 25 degree C typical (base) - Hardener Component low
viscosity clear liquid.
Spreading rate: +/- 7.5 sq metre / litre @ 50 micron dry film thickness
Finish: High-Gloss
Colour Availabiltiy: White, Clear and full range of toners.
Recommended Surface:
Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly
cleaned, dry and free of dust, oil and grease.
Recommended Primer: 2K M.S Primer or a nitrocellulose automotive primer.
Overall Coatability: N/A
Recommended Thinner: Good Quality 2K Thinner
Application:
Application Method: Spray Application
Viscosity: 16 to 18 Seconds FC 4 @ 25 degree C.
Recommended D.F.T. +/- 50 Microns 2 to 3 coats (wet on wet)
Drying Conditions Surface Dry: 1-2 hours. Hard dried overnight and can be dried @ 60 degree C
for 1-2 hours (after flash off period)
Flash off time: 20-30 Minutes
Pot Life: 4-6 Hours @ ambient temperature.
PREMIUM 2K CLEARCOAT
500ml
1lt
5lt
PREMIUM 2K FAST HARDENER
500ml
1lt
5lt
PREMIUM 2K TONERS
500ml
1lt
5lt
PREMIUM 2K M.S PRIMERS
500ml
1lt
5lt
Copyright © Premchem 2024
Site Development & Maintenance: Designergraphix.co.za