BC Red Diamond

Showing all 2 results

BC RED DIAMOND

RED DIAMOND BASECOAT TONERS

1lt

3.5lt

PRODUCT DESCRIPTION

A wet on wet two stage application system for metallic colours giving state of the art finishes for use in the automotive industry. Chemical Basis: Polyester / Melamine / CAB General Qualities: High quality finish for the refinish trade relating to metallic finishings. Physical properties: Density 1.15 Typical (depending on colour) Flash Point: above 21 degree C. Solid content varies considerably, depending on colour. Viscosity: N/A Spreading rate varies considerably, depending on colour. Finish: Semi-Matte Colour Availabiltiy: Variety of silvers and full range of toners.

Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: 2K M.S Primer Overall Coatability: Twin Pack Top Coat Clear Recommended Thinner: Good Quality B/C Thinner Application: Mixing Ratio: Application Method: Spray Application Viscosity: 16 to 18 Seconds FC 4 @ 25 degree C. Recommended D.F.T. +/- 25 Microns Drying Conditions Surface Dry: 10-20 Minutes @ 25 Degree C Flash off time: 5-10 Minutes Pot Life: N/A One pack Product

Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.

RED DIAMOND BASECOAT PEARLS