Copyright      PREMCHEM 2014. All rights reserved.
c
PREMCHEM SELF-ETCH PRIMERS
PRODUCT DESCRIPTION
Home Home Products Products Contacts Contacts Our Profile Our Profile
One pack self etch primer for use on steel as an adhesion promoting primer with anti-corrosive properties. Chemical Basis: Phenolic re-inforced polyvinyl butyral resin system with anticorrosive pigmentation and acid etching properties to steel. General Qualities: Fast drying, sprayable, with excellent adhesion promoting properties. Physical properties:   Density: Typical 0.93 Flash Point: below 21 degree C. Solid content Typical 20% by W/T Viscosity: +/- 60 secs FC 4 @ 25 degree C typical Spreading rate: 4-5 sq metre /  litre @ \ 25 microns dry film thickness Finish: Semi-Matte Colour Availabiltiy: Red Oxide, Grey, Black Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: N/A Overall Coatability: Can be coated with N/C, Q/D, A/D & 2 Pack auto refinish products. Recommended Thinner: Grade A Lacquer Thinner Application: Mixing Ratio: one-pack product Application Method: Spray Application Viscosity: 14-16 Secs FC 4 @ 25 degree C Recommended D.F.T. 10-15 microns Drying Conditions Surface Dry: 5-10 mins - Hard dry: 1 Hour Flash off time: 5-10 mins Pot Life: One pack product Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS