Copyright      PREMCHEM 2014. All rights reserved.
c
PREMCHEM POLYESTER RESIN (F.G)
PRODUCT DESCRIPTION
Home Home Products Products Contacts Contacts Our Profile Our Profile
Polyester resin used in conjunction with fibre glass matting for general repair work. Chemical Basis: Pre-accelerated resin, cured with liquid peroxide catalyst. General Qualities: Rapid curing, for general repair work when used with fibreglass matting. Physical properties:   Density: Typical 100 Flash Point: above 23 degree C. Solid content 60% Viscosity: low viscosity laminating resin Spreading rate: depending on repair work Colour Availabiltiy: Clear Resin Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: N/A Overall Coatability: Can be coated with most types of topcoats. Recommended Thinner: N/A Application: Mixing Ratio: 2& catalyst to base Application Method: hand lay method lay up Viscosity: as supplied Recommended D.F.T.  Drying Conditions Surface Dry: can vary between 15 mins to 1 hour Flash off time: N/A Pot Life: 15-20 mins after mixing catalyst Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS