Copyright      PREMCHEM 2014. All rights reserved.
c
PREMCHEM PLASTIC PRIMER
PRODUCT DESCRIPTION
Home Home Products Products Contacts Contacts Our Profile Our Profile
One-pack product suitable as a primer application for many plastic surfaces which are not notoriously difficult to paint. Chemical Basis: Unique resin base providing a strong bond to plastic substrates and exceptional flexibility. General Qualities: Flexible primer with good adhesion, sand ability and fast drying properties. Physical properties:   Density: 1.03 Typical.  Flash Point: below 23 degree C. Solid content: Tupical 41% W/T & 12% by volume. Viscosity: +/- 1min 20secs FC4 @ 25 degree C Spreading rate: +/- 5 sq metre / litre @ 25 micron dry film thickness Finish: Matte Colour Availabiltiy: Grey, Clear Recommended Surface: Preparation: Should only be applied over a suitable primed surface. Surface should be thoroughly cleaned, dry and free of dust, oil and grease. Recommended Primer: N/A Overall Coatability: Can be coated with a variety of topcoats i.e: Nitocellulose, Mettalic basecoats, 2k Paints Recommended Thinner: Grade A Lacquer thinner. Application: Mixing Ratio: One PAck product Application Method: Spray Application (small touch up areas by brush) Viscosity: +/- 14secs FC 4 @ 25 degree C. Recommended D.F.T. +/- 10-15 Microns dry film thickness Drying Conditions Surface Dry: 5 mins - Overcoat able 15 mins - hard dry 30 mins Flash off time: 5-10 minutes Pot Life: N/A One pack product Health and safety Data Use in a well ventilated flameproof area. Protective Clothing, gloves & goggles should be worn with an air fed mask when spraying. Storage: Products contain highly flammable solvents. Store in a flame proof area, away from any source of flame or excessive heat. The information herein is accurate and factual to the best of our knowledge and is given in good faith, However, no warranty is implied or expressed in respect of any recommendation or suggestions contained herein. The onus is on the end user to ensure the sustainability of this product to meet their requirements. Health & Saftey procedures when using this product are the end users responsibility.
Designed & Maintained By:   Designer Graphix webmaster webmaster Customer Log in Back to Products Request MSDS